Page 416 - Wago_PCB_TerminalBlocksConnectors_Volume2_2015_US

Female Headers with Solder Pins
6 Pin Spacing: 5 mm, 5.08 mm
414 MCS MIDI Classic
● Horizontal or vertical PCB mounting via straight or angled solder pins

● For “board-to-board” and “board-to-wire” connections
● Touch-proof PCB outputs

● Easy-to-identify PCB inputs and outputs

● With coding fingers

Technical data:

Pin Spacing 5 mm 5.08 mm Derating Curve
0.197 in. 0.2 in.
Ratings per IEC/EN 60664-1 IEC/EN 60664-1 232-232 female connector with 231-602 male header
Pin spacing: 5 mm / Conductor size: 2.5 mm “f-st”
2
Overvoltage category III III II III III II Based on: EN 60512-5-2 / Reduction factor: 0.8
Pollution degree 3 2 2 3 2 2 Current in A
Rated voltage 320 V 320 V 630 V 320 V 320 V 630 V 45
Rated surge voltage 4 kV 4 kV 4 kV 4 kV 4 kV 4 kV 40
Nominal current 12 A 12 A 12 A 12 A 12 A 12 A 35
Approvals per UL/CSA UL/CSA 30
Use group UL 1059 B C D B C D
Rated voltage 300 V – 300 V 300 V – 300 V 25
Nominal current UL 15 A – 10 A 15 A – 10 A 20
Nominal current CSA 15 A – 10 A 15 A – 10 A 15
The MCS MIDI connection system is UL 1977 approved and capable of up to 600 V for factory wiring. 10
5
Solder pin data: 0 10 20 30 40 50 60 70 80 85
Solder pin: length/width 5 mm / 0.6 x 1 mm Ambient operating temperature in °C
Solder pin: drilled hole diameter 1.3 +0.1 mm 2-, 4-, 6-, 12-, 24-pole Conductor rated current

Material data: MCS MIDI accessories: Pages:
Material group I
Insulating material Polyamide 6.6 (PA 6.6) Marking accessories 570 – 573
Flammability rating per UL 94 0V Test plug adapter 478
Lower/Upper limit temperature -60 °C / +85 °C Test plug 568
Contact material Copper alloy Screws 576
Contact plating tin-plated
MCS connectors are also available upon request with gold-plated or partially gold-plated contact surfaces.
Depending on the version requested, “item no. suffix . . . /010-000” is added to the “basic item no.”

MCS — MULTI CONNECTION SYSTEM includes connectors without breaking capacity in accordance with
DIN EN 61984.
When used as intended, these connectors shall not be connected/disconnected when live or under load. The circuit
design should ensure header pins, which can be touched, are not live when unmated.

Additional approvals and corresponding ratings can be found at www.wago.com. For additional technical information, see Section 13.