Page 2 - Parker - Fulflo ParMax Filter Cartridges
P. 2

®
          Fulfl o  ParMax Filter Cartridges



          Specifi cations
          Materials of Construction:           Retention Ratings (99.98%):           Recommended Operating Conditions:
          Media:                               1, 3, 4.5, 10, 20, 30, 40 and 90 µm   Flow Rate
          RCP - Polypropylene                                                        Up to 175gpm (662 lpm)/20” element
                                               Maximum Operating Conditions:
          RMG - Microfi berglass                                                      Up to 350gpm (1325 lpm)/40” element
                                               Maximum Temperature                   Up to 500gpm (1892 lpm)/60” element
                                               176°F (80°C) @ 30psid (2.1bar)
          Support/Drainage:                                                          Change-out Pressure
          Polypropylene                                                              35psid (2.41bar)
                                               Maximum Differential Pressure:
                                               70psi (4.8bar) @ 77°F (25°C)
          Hardware:                                                                  Dimensions (nominal):
                                               30psi (2.1bar) @ 176°F (80°C)
          Polypropylene                                                              Outside Diameter: 6” (152mm)
                                                                                     Inside Diameter: 2.9” (74mm)
          O-rings:
          EPR, Buna-N, Viton , silicone
                         ®

                                     Flow vs dP
                             (2.9" Cartridge Inlet Orifi ce)





















               Note: The 2.9˝ inlet orifi ce of the ParMax Cartridge is the fl ow-limiting factor



          Ordering Information

                                                                                          PP



                Cartridge Code      Micron Rating         Length        Seal Material  End Cap Confi guration
           Code  Description        Code  μm          Code  Inches   Code  Description  Code  Description
           RCP   Polypropylene      010  1.0          20   20˝ (50.8 cm)  E  EPR     PP  435 O-ring/Closed
           RMG   Glass              030  3.0          40  40” (101.6 cm)  N  Buna-N
                                    045  4.5          60  60” (152.4 cm)  S  Silicon
                                    100  10                           V     Viton ®
                                    200  20
                                    400  40
                                    900*  90
                                   * Available only in polypropylene media (RCP)
          © 2010 Parker-Hannifi n Corporation                                         Viton is a registered trademark of E.I. DuPont de Nemours & Co., Inc.
          Process Advanced Filtration Division
          All Rights Reserved                                                                                SPEC ParMax  01/10
          Specifi cations are subject to change without notifi cation
          For User Responsibility Statement, see www.parker.com/safety




                                                             54
   1   2