Page 110 - Parker - Parker Pneumatic

Catalog PDN1000-3US Actuator Products – Round Body Cylinders
Parker Pneumatic SRX Series

SRX Series

• Continuous position feedback
• Bore sizes: 1-1/16" to 3"
• Signal input: 5 to 24 VDC
• Signal output (w/o controls): DC ratiometric voltage*
• Signal output (w/controls): 0 to 10 VDC or 4 to 20 mA
• Strokes: Available in any practical stroke length up to 24"
* Mega Ohm impedence interface device suggested for limiting sensor
current if controller is not used.

Operating information B
Operating pressure: 150 PSIG (10.3 bar)
Temperature range: 40°F to 160°F (4.4°C to 71°C)
Filtration requirements: 40 micron, dry filtered air
Ordering information Actuator Products
1.50" DXP P SRX B F S 3 6.00" Round Body Cylinders

Bore size Connector style Piston Special Stroke
1.06" P Plug B Bumper* S Special Stroke in
1.50" F inches
2.00" Flying leads Leave blank if not Leave blank if special
required.
modification is not
2.50" Mounting s tyle required. SR/SM/SRD/SRDM Series
3.00"
D Nose mount
DXP Nose and pivot mount Seals Non-standard rod dimension
BFD Front block mount F Low friction 3 Non-standard dimension
* Incorporating bumpers adds 1/4" of overall length to the cylinder. Leave blank if not Leave blank if special rod end
required. dimension is not required. SRX Series
Sensors NOTE: For non-standard / special rod ends,
For sensors see page B339. see below.

For ordering purposes, when special options or common modifications are requested, the factory will assign a sequential part P1L Series
number in place of the model number.
Non-standard rods

For non-standard rod dimensions, or undersized rod end P1A Series
threads, put a “3” in model number and describe the rod using
the letters shown in the drawing. It is necessary to specify only
those dimensions that are non -standard.
LE is measured in retracted position. P Series
Full diameter rod end threads Undersized rod end threads
LE LE
A W W
AM* AM*
CC C V* CC A C V*

B* B*

D Wrench D Wrench
Flats MM* Flats MM*
KM* KM*
* Requires an “S” designation in model number.
B109 Parker Hannifin Corporation
Pneumatic Division
Richland, Michigan
www.parker.com/pneumatics