Page 30 - Cannon Globe Trotter 3Roda

MI NI & MI CRO DATA CENT RE

C O O L I N G O P T I O N S

COOLING SYSTEM TYPE COMPARISON
Water Cooling:

Water / Glycol fluid is pumped at 14°C to the cabinet
which has an air to water cooling coil, the heat in the
cabinet is then exchanged into the water and
returned warm to the external Chiller. Water based
cooling is both efficient and easily controlled, it is
suitable for low < 5kw to very high cooling
Cooling units requirements >60kw and dynamic changes in heat
may be fitted to load. Water Chillers may use high COP systems and
most of Cannons adiabatic cooling to reduce power consumption.
large range of
indoor and Chilled water is often available on site and is easily
outdoor provisioned if not. Cooling units may be mounted on
cabinets. any face of the cabinet. Near silent <60db.
DX Split system: (Direct Exchange to Gas) 8 to
40kw.
In a DX split system, an external condenser /
compressor pumps a gas to convert into a liquid, this
is piped to the evaporator coil in or beside the
cabinet and when the liquid passes through the coil it
removes heat from the cabinet. The gas then flows
back to the compressor / condenser and the cycle
repeats. DX systems require a specific minimum heat
load for operation and DX split system cost less than
a comparable chilled water system, although they
cost more to run. Near silent <60db operation.

DX Packaged: A single unit as above, compact, highly
cost effective systems. Available in sizes of 1 to 10kw
they exchange the interior heat to the air outside the
cabinet (heats the room). 62-72db average noise
levels (ambient temperature dependent)

Mounting types:- Side/With In row/Inside
cabinet, Rear & Front door, Roof, Ducted.

Capacity:-Cooling systems of up to 60kw
per cabinet in N, N+1, 2N and 2N+1
redundancy possible.

Deployment:- Indoor, Outdoor, Track &
Street side, Marine & Seismic, EMC & MIL
spec available.

3.1
T : + 4 4 ( 0 ) 1 4 2 5 6 3 2 6 0 0 | C A N N O N T E C H . C O . U K | S A L E S @ C A N N O N T E C H . C O . U K