Page 79 - Dante Controller User Guide
P. 79

Dante Controller User Guide



                  n User-defined device name

                  n User-defined channel labels
                  n Clock configuration (clock master / external clock master setting)
                  n Static IP addresses
                  n Redundancy configuration
                  n Sample rate setting (including pull-up/down)
                  n Latency setting
                  n Any existing audio routes

               Supported devices allow you to 'Clear Config' instead of Factory Reset. Clear Config wipes the same
               configuration settings listed above, but allows you to optionally keep the IP settings (i.e. retain the Dante
               Redundancy settings, and any static IP addresses currently configured in the Network Config tab).
               A reboot is required after clearing the configuration for the changes to take effect. Some devices will allow
               you to automatically reboot after clearing the configuration. If this option is not available, a manual reboot is
               required.
















                Network Config Tab

               Use the Network Config Tab to toggle supported devices between Redundant and Switched modes, and to
               specify static IP addresses for a device's Ethernet ports.








































             Copyright © 2020 Audinate Pty Ltd. All rights reserved.                                  -79-
   74   75   76   77   78   79   80   81   82   83   84