Page 217 - MMS Jim Humbl's Heart Mind Healing

198 MMS Health Recovery Guidebook

Step 4

q Determine how many drops of MMS1 (activated MMS)
to use. Depending on the size of the infection, use from
5 to 20 drops of MMS1 (using 4% HCl or 50% citric
acid to activate). Use 5 drops for a MRSA infection or
a boil about 1/2 inch (1.25 cm) in diameter. Use 10
drops of MMS1 for a MRSA infection or boil 1 inch (2.5
cm) across. For any sore 2 inches (5 cm) or larger in
diameter, use 15 to 20 drops.

Step 5

q Using Step 4 above as your guide to the number of
drops to use, put these drops in your container and
immediately cover the infection or boil. Be careful to
hold the container so that the MMS1 will not run down
on your skin, and so you are not allowing any gas to
escape. You may have to lie down or lean over,
depending on the location of the boil.

q Do not apply this for longer than five minutes
maximum, to avoid burning the skin. If one has
particularly sensitive skin, it would be best to do this
procedure for only three minutes the first time in order
to see how the skin reacts. If the skin reacts well, it
can be repeated again in four hours (see directions
below), and for up to five minutes the second time if
needed. But remember, no longer than five minutes.

Step 6

q The chlorine dioxide gas generated by the activated
MMS will cover the infection in seconds, and you will
be able to see the infection open up, and the inside of
the infection will drain out in a couple of minutes.
Stand, or sit, or lie down so that the infection—be it on
the side of your arm, or face, or leg—can drain,