Page 211 - Modernfold Architectural Products

Acousti-Seal Pocket Doors Technical Data
®
10 22 26 (10650) Operable Partitions

ACOUSTI-SEAL 900 SERIES TECHNICAL DATA
®

THE ACOUSTI-SEAL POCKET DOOR
®

• Acousti-Seal Pocket Doors are either acoustic or • Pocket Doors are pre-finished with all available
®
non-acoustic solutions to conceal panel storage finish options or uncovered for field finishing
areas • Custom finish solutions available to match or blend
• Pocket Doors are prefabricated with jambs and with existing design
hardware installed

Modernfold Model
Acousti-Seal Pocket Door
®
This specification along with product information and model details can be downloaded from www.modernfold.com
SPECIFICATION - SECTION 10 22 26 (10650) OPERABLE PARTITIONS

PART 1 - GENERAL concealed protection of the edges of panel
skin.
See Operable Partition Specification for details. 4. Panel skin shall be (select one):
a. 1/2-inch (13mm) tackable 100% recycled
PART 2 – PRODUCTS gypsum board, class “A” rated single
material or composite layers continuously
See Operable Partition Specification for details. bonded to panel frame. Acoustical ratings
of panels with this construction – 47 STC.
2.7 OPTIONS b. 1/2-inch (13mm) NAUF medium density
C/D. Available Accessories/Options: fiberboard, single material or composite
1. Pocket Doors: Acousti-Seal Pocket Doors by layers continuously bonded to panel
Modernfold, Inc. frame. Acoustical ratings of panels with this
2. Pocket Door configuration shall be manually construction – 47 STC.
operated (select one): c. Roll-formed steel wrapping around panel
a. Type I single door hinged to a jamb on one edge. Panel skins shall be lock formed and
side as required. welded directly to the frame for unitized
b. Type II double door hinged to a jamb on construction. Acoustical ratings of panels
each side and closing in the center. with this construction – 50 STC.
c. Type III double doors hinged to a jamb 5. Panels hinges shall be (select one):
on each side and closing in the center. a. Full leaf butt hinges, attached directly to
One of the door panels is equipped with a panel frame with welded hinge anchor
smaller hinged panel that folds back when plates within panel to further support hinge
the operable partition is extended into the mounting to frame. Hinges mounted into
pocket. panel edge or vertical astragal are not
d. Type IV bi-fold door hinged to a jamb on acceptable.
one side as required. b. SOSS® invisible laminated hinge with
3. Panels shall be nominal 3-inch (76mm) thick antifriction segments mounted between
in manufacturer’s standard width. All panel each heat treated link. Hinge to be
horizontal and vertical framing members attached directly to panel frame. Welded
fabricated from minimum 18-gage formed internal hinge bracket shall support the
steel with overlapped and welded corners for hinge and allow for adjustment of hinge
rigidity. Frame is designed so that full vertical plates. Concealed hinges or hinges
edges of panels are of formed steel and provide mounted into panel edge or vertical

Please contact your local Modernfold distributor for further assistance, or visit our website at www.modernfold.com. 1