Page 93 - Modernfold Architectural Products
P. 93
Acousti-Seal Encore Technical Data
®
®
10 22 26 Operable Partitions
ACOUSTI-SEAL ENCORE SERIES TECHNICAL DATA
®
®
B. Double Pass Doors: D. Broken, cracked, chipped, deformed or
1. Matching pass door same thickness and unmatched panels are not acceptable.
appearance as the panels. No center post
is permitted. Active leaf to be trimless and 3.2 CLEANING AND PROTECTION
equipped for panic operation. No threshold A. Clean partition surfaces upon completing
will be permitted. installation of operable partitions to remove
2. Hardware: dust, dirt, adhesives, and other foreign
a. Hand pull with push plate. materials according to manufacturer’s written
b. Lever handles both sides of door instructions.
c. Panic hardware with or without locking B. Provide final protection and maintain
lever handle. conditions in a manner acceptable to the
d. Automatic door closer. manufacturer and installer that insure operable
e. Self-illuminated exit signs. partitions are without damage or deterioration
C. Work Surfaces: at time of Substantial Completion.
1. Markerboard: White enamel on steel, bonded
to the face of the panel with horizontal 3.3 ADJUSTING
trim without exposed fasteners. Trim is not A. Adjust operable partitions to operate
acceptable on vertical edges to provide smoothly, easily, and quietly, free from
uninterrupted work surface. binding, warp, excessive deflection, distortion,
2. Tackboard: Minimum 1/4-inch (6.35 mm) nonalignment, misplacement, disruption, or
natural cork, covered with vinyl or fabric, with malfunction, throughout entire operational
horizontal trim without exposed fasteners. Trim range. Lubricate hardware and other moving
is not acceptable on vertical edges. parts.
D. Available Accessories/Options:
1. Pocket Doors: Acousti-Seal Pocket Doors 3.4 EXAMINATION
by Modernfold, Inc., with same finish and A. Examine flooring, structural support, and
appearance as the adjacent panels. opening, with Installer present, for compliance
2. Intersecting partition interface. with requirements for installation tolerances
and other conditions affecting performance
PART 3 – EXECUTION of operable partitions. Proceed with
installation only after unsatisfactory conditions
3.1 INSTALLATION have been corrected.
A. General: Comply with ASTM E557, operable
partition manufacturer’s written installation 3.5 DEMONSTRATION
instructions, Drawings and approved Shop A. Demonstrate proper operation and
Drawings. maintenance procedures to Owner’s
B. Install operable partitions and accessories after representative.
other finishing operations, including painting B. Provide Operation and Maintenance Manual
have been completed. to Owner’s representative.
C. Match operable partitions by installing
panels from marked packages in numbered
sequence indicated on Shop Drawings.
STC CONSTRUCTION AND TRACK SYSTEM HEIGHT LIMITATIONS
Acousti-Seal Encore ® 52 STC 54 STC 56 STC
®
#17 Smart Track 20’-4” (6198 mm) 20’-4” (6198 mm) 18’-4” (5588 mm)
#14 Smart Track* 30’-4” (9246 mm) 30’-4” (9246 mm) 30’-4” (9246 mm)
#17 Right Angle Track 10’-4” (3150 mm) 8’-4” (2540 mm) N/A
RT100 Right Angle Track 16’-4” (4978 mm) 16’-4” (4978 mm) 16’-4” (4978 mm)
RT200 Right Angle Track 20’-4” (6198 mm) 20’-4” (6198 mm) 20’-4” (6198 mm)
*Custom engineered solutions up to 60-feet.
4 Please contact your local Modernfold distributor for further assistance, or visit our website at www.modernfold.com.