Page 65 - RAIDO PORTFOLIO 2021
P. 65
RAIDO PRODUCT PORTFOLIO
INDUSTRIAL LUBRICANTS
RAIDO Slideway Oil 68 AGMA 9005-E02; This oil is a machine tool lubricant specially designed for tableway
ST-B.07.01 DIN 51517-3 CLP; lubrication, with emphasis on superior stick-slip properties. This
DIN 51524-2 HLP; machine tool lubricant also meets the requirements of hydraulic
RAIDO Slideway Oil 220 ISO 11158 HG; systems, gear boxes and spindles in most machine tools.
ST-B.07.04 ISO 19378 GA & GB;
FZG 12
RAIDO Mould Oil EDZ This is a light coloured concrete mould oil, based on high- This mould oil is recommended for steel- and coated wooden
grade refined base oils, containing non-toxic surface-active moulds and should be applied, by spraying, swabbing or brushing, as
NS-B.18.01
compounds. Together with the bleeding water from the a thin layer (1 litre at 40-60 m²) to get the best results. After
concrete, this mould oil provides a low interfacial surface- applying the overspill must be removed otherwise it tends to give oil
tension, which gives a smooth surface finish of the concrete. marks on the concrete when too much is used. This mould oil can
also be used for the manufacturing of concrete in heated moulds.
RAIDO Mould Oil TWD Plus This is a light coloured concrete mould oil for the construction This mould oil is recommended for steel and coated wooden moulds
ST-B.19.01 of houses, buildings, subways and bridges. This mould oil is and should be applied, by spraying, swabbing or brushing, as a thin
based on high grade refined base oils and a suitable solvent, layer.
containing non-toxic surface-active and anti-corrosive For coated wooden moulds: use 1 litre of this mould oil at 30-40 m²
compounds. Together with the bleeding water from the For steel moulds: use 1 litre of this mould oil at 40-50 m².
concrete, this mould oil provides a low interfacial surface After applying the overspill must be removed, otherwise it tends to
tension, which gives a smooth surface finish. give oil marks on the concrete when too much is used. This mould
oil can also be used for the manufacturing of concrete in warm
moulds.
RAIDO Furkata P 32 DIN 51506 VDL; This compressor oil is recommended for the crankcase and cylinder
NS-B.28.04 DIN 51352-2 lubrication of reciprocating air compressors, but also for the
lubrication of drip feed rotary sliding vane compressors. This
RAIDO Furkata P 46 compressor oil has low carbon-forming tendencies and minimises
NS-B.28.05
the formation of deposits in the discharge system at the
RAIDO Furkata P 68 temperature range where these compressors operate. Due to the
ST-B.28.01 high quality of this compressor oil, mostly the service interval can be
extended.
RAIDO Furkata P 100
NS-B.28.02
RAIDO Furkata P 150
NS-B.28.03
PAGE 65