Page 57 - HIL Operatives Training Manual V4 16022024_Neat

O P E R A T I V E S T R A I N I N G M A N U A L V E R S I O N 4

16 High Pressure Fluid Injection Injuries

High-pressure equipment such as hydraulic lines, high-pressure grease guns and high-pressure fuel injection
systems, have the potential to cause serious injury or even death, if not properly
used and properly maintained.

Fluid in this type of equipment is under pressure ranging from 600psi to
12,000psi (4MN/m2 to 83MN/m2).

The velocity of fluid forced through a pinhole break in a hydraulic hose
can be in excess of 250 metres per second (600ft/s).

This is close to the muzzle velocity of a rifle, and is sufficient to drive fluids
through protective clothing, including protective gloves.

Penetration of the skin can occur at pressures as low as 100psi
(700kN/m2). Skin penetration can occur up to 100mm (4”) away from the
fluid source.

Why are high-pressure injection injuries so serious?

High-pressure injection injuries usually require emergency surgical treatment.

When fluid enters the body it begins to kill tissue. Gangrene can set in if the injury is not treated promptly. There
is also a risk of blood poisoning and bacterial infection. Surgery is usually required to remove the dead tissue
and clean out the injected fluid from the wound.

Failure to act quickly may result in the need to amputate fingers and limbs.

Risk of amputation significantly increases if the wound is not treated within 10 hours.

Unfortunately, fluid injection is often painless and the point of entry through the skin is usually very
small and has a harmless appearance

Pain and swelling may not appear for several hours after injection (sometimes it can take a couple of
days before pain and swelling are experienced)

Page 56 of 142