Page 34 - ba;ayage training manual

Step 14. Finally select the natural parting and place the Colorage Meches along the parting.
The thickness of the sections, the amount of Colorage Meches and where they are placed all
depend on the amount of lift you are looking for on the top layer of the hair.

Please see Fig 17

Steps so far:

Step 1. Shampoo, condition and blow dry the hair.

Step 2. Take a horizontal parting in the nape of the neck.

Step 3. Mix a basic high lift powder bleach with either 6% or 9%.

Step 4. A thin half a centimeter deep horizontal section
directly below the horizontal parting in the nape of the neck.

Step 5. Pinch the thin half a centimeter deep horizontal section off the needle of the tail comb
using your thumb and forefinger.

Step 6. Open a Colorage “A” Meche then pull the pinched section of hair through the slot.

Step 7. Slide the Colorage “A” Meche up the hair until it reaches the scalp and fits flush along

the horizontal parting.

Step 8. Now paint the bleach through the slots of the template.

Step 9. Continue painting bleach directly onto the hair past the template to the ends of the hair

Step 10. It is possible to slide a Colorage “B” Meche under the ends of the hair to act as an
Extender Meche.

Step 11. Finish by covering the bleach with two Colorage B Meches.

Step 12. T the next horizontal parting is from the top of the ear to the top of the other ear.

Step 13. Take the next parting 4 centimeters above the ears.

Step 14. Finally select the natural parting and place the Colorage Meches along the parting.

Fig 17 Step 14. Finally select the natural parting and place the Colorage Meches along the parting.