Page 20 - Foton Workshop Manual - Aumark (BJ1099)

01-14 INTRODUCTION - GENERAL RULES OF MAINTENANCE OPERATION

(c). Horn button assembly (Configured with air
bag).
• When storing the horn button assembly,
alway place them face up and never
place any items on the horn button.
• Never measure the resistance of
explosive device of air bag, it will cause
the sudden expansion of air bag, this is
very dangerous.
• Never apply any grease or cleaning fluid
on the horn button.
• Store the horn button assembly in the
place where the ambient temperature is
lower than 93 ℃, the humidity is not high
humidity and there is no electromagnetic
interference.
• Before the use of welding, always
disconnect air bag ECU connector.
• Before throwing away the old parts of the horn button assembly, always use the special
tool to ignite the air bag in the safe place with no electromagnetic interference. (Refer to
"Chapter 42 Supplemental Restraint System - Driver Air Bag, End-of-Live Disposal")

3. Electrical control
(a). Disconnect and connect the battery
negative cable.
• Before electrical maintenance, be sure
to disconnect battery negative cable to
prevent accident caused by reasons
such as short circuit.
• Before disconnecting or connecting the
battery cable, be sure to turn off ignition
switch and all electric appliance switches
and completely loosen the fixed nut of
cable. Do not distort or pry cable.
• Record for clock and radio, etc. will
be reset after disconnecting battery
negative cable. All necessary data shall
be recorded before maintenance.

Page 20