Page 85 - Demo

2.10/69
REV 22
REV 22
PAGE 69
A330
CHINA AIRLINES
ATA
EQUIPMENT
MANUAL
REMARKS
OVHD RESET panel
System control panel
27
SFCC FLAPS 1 (2) (If SB A330 -27-3201 is accomplished)
2
On ground only:
Only in case of F/CTL FLAP SYS 1(2) FAULT alerts:
– Pull FLAPS 1 (261VU) or FLPAS 2 (262VU)
reset button
– Waits 5 secs
– Push FLAPS 1 or FLAPS 2 reset button. Warning:
– Do not perform any reset of the flaps control
unit during flaps movement, and
– Do not reset more than one SFCC channel at
the same time.
SFCC SLATS 1 (2) (If SB A330 -27-3201 is accomplished)
2
On ground only:
Only in case of F/CTL SLAT SYS 1(2) FAULT alerts:
– Pull SLATS 1 (261VU) or SLATS 2 (262VU)
reset button
– Waits 5 secs
– Push SLATS 1 or SLATS 2 reset button. Warning:
– Do not perform any reset of the slats control
unit during slats movement, and
– Do not reset more than one SFCC channel at
the same time.
28
FCMC
2
– If reset is done before engine start, ZFW and ZFWCG must be re-entered on the MCDU (INIT B page).
– If the reset is done after engine start, actual GW and CG displayed on the MCDU FUEL PRED page are computed by the FE. However, the GW computed by the FE may be less accurate, therefore, when time permits:
• If the reset is successful, the actual GW and CG must be re-entered on the MCDU FUEL PRED page,
• If the reset is unsuccessful, the flight crew must determine the FOB from the engine start fuel quantity minus the FU quantity indication.
In the case of triggering of FUEL ZFW ZFCG DISAGREE. If the ZFW, ZFWCG, ECAM GW are the same as the loadsheet values, but the difference between the ECAM CG and the loadsheet CG is more than 2 %:
On ground:
– Reinsert the ZFW and ZFCG values.
If the ECAM caution is still displayed after reinsertion:
• Simultaneously pull FCMC 1 and FCMC 2
reset buttons.
• Simultaneously push FCMC 1 and FCMC 2
reset buttons.
If unsuccessful, on ground:
– Simultaneously pull FCMC 1,FCMC 2, FMGEC 1 and FMGEC 2 reset buttons
– Simultaneously push FCMC 1,FCMC 2, FMGEC 1 and FMGEC 2 reset buttons Refer to Computer Reset Table - 22 - Auto Flight for additional information regarding the FMGEC resets.
30
PHC WHC
3 2
Associated heating is interrupted, when the reset pb is pulled.