Page 8 - INSTALLATION INSTRUCTIONS BOOK_Neat
P. 8

NANO4LIFE for porous surfaces is instantly ready to apply. As an application
                   method spraying with particular spraying devices are recommended. Best results
                   were realized by using HVHP nozzles. These nozzles enalbe a very small droplet
                   size. Working on substrates which are recently formed and still damp is also
                   possible.

                   Industrial Spraying Devices:

                   The amount of nozzles (about 2-4) are depending on the width of the substrate. The
                   width should be coverd completely by the jet of spraying. Two or three nozzles are
                   sequentially placed each in a distance of 30-50cm (depending on absorbancy). Thus
                   the penetration of NANO4LIFE for porous surfaces will be delimited and an optimal
                   effect is obtained with a minimum of consumption.

                    Manual Spraying:

                   The manual sprinkled areas are considered to work on in 2 processes (wet in wet).
                   Depending on porosity of the substrate the procedure has to be repeated.
                   In case of large areas, spraying should proceed in every square meter. Right after
                   the first contact NANO4LIFE for porous surfaces is taken in through the pores of
                   the  surface.  The  same  area  should  be  sprinkled  in  a  second  process  after  2-5
                   minutes. Often a developing of pearls can already be observed on the substrate. A
                   forming of paddles should be avoided in any case.

                   Additional Application Methods:

                   Besides spraying it is also possible to dip, brush or spread it with a roll of lambskin. In
                   this case usually an increasing consumption must be calculated.

                   Cure Times:

                   Few  minutes  after  applying  NANO4LIFE  for  porous  surfaces  has stabilized  so  it
                   can be walk on with clean and soft footgear. The entire cure is reached after 24 up to
                   48 houres (ambient temperature 20°C). Depending on ambient temperature the cure
                   temperature may differ.

                   Storage Temperature:

                   From + 4 °C To + 30°C
                   From –10°C To  + 30°C possible on request

                   Consumption:

                   The consumption depends on the absorbency of the substrates and differs between
                   30-200ml/m². Relating to that, areas of 5m² up to 30m² and more can be covered
                   with only 1 liter.

                   These information s concerns the products

                   Nano4-stone - Nano4-wood - Nano4-deck wooden






                   NANO4LIFE EUROPE – Vouliagmenis Ave.  318 – Ag. Dimitrios  -173 43 Athens  – Greece
                   Tel:0030 213 0272732 Mob:0030 6944932317 Email: info@nano4life.co
   3   4   5   6   7   8   9   10   11   12   13