Page 59 - FLEXTRAY Cable Management - Complete Catalog

Flextray™ - Installation

90° Horizontal Bends (Long Radius)
™
• Make your own field cut horizontal sweeps using Clearshear to make safe, smooth cuts
• Can be made from any tray width and depth with any available finish
• Cut as many Segments as required to control sweep radius (use chart for recommendations)
• One (1) WASHER SPL KIT is required to connect each cut segment minus one, this segment
uses one (1) SPLICE BAR, two (2) FTHDWE 1/4 and two (2) BTM WASHER Installation

• Illustration shown below is for a 8” (200mm) width Component Qty.
• 1.5” deep Flextray has only one (1) side wire Segments FTHDWE 1/4
2” deep Flextray has two (2) side wires - shown Flextray To Be WASHER & SPLICE
Width Removed SPL KIT BTM WASHER BAR
4” deep Flextray has three (3) side wires
6” deep Flextray has four (4) side wires 4” (100mm) 21 2 1
6” (150mm) 32 2 1
8” (200mm) 43 2 1
12” (300mm) 65 2 1
16” (400mm) 76 2 1
18” (450mm) 87 2 1
20” (500mm) 10 9 2 1
24” (600mm) 11 10 2 1
30” (750mm) 13 12 2 1
32” (800mm) 13 12 2 1

90° Horizontal Bend From (2) Straight Sections

• Cut required number of wire side sections listed in Flextray Side Sections WASHER SPL KIT
chart per the illustration below Width To Be Removed Qty.
(Illustration is for a 8” (200mm) width)
• 1.5” deep Flextray has only one (1) side wire 4” (100mm) 12
2” deep Flextray has two (2) side wires - shown
6” (150mm) 22
4” deep Flextray has three (3) side wires
8” (200mm) 22
6” deep Flextray has four (4) side wires
12” (300mm) 32
16” (400mm) 43
18” (450mm) 53
20” (500mm) 53
24” (600mm) 64
30” (750mm) 84
32” (800mm) 84

57