Page 1034 - 2006 HARLEY FLSTCI SERVICE MANUAL

7-29

Bearing in Main Driver Gear Figure 7-38. Installing Transmission Side Needle 1 2 Pawl (part of shifter shaft lever) Figure 7-39. Shifter Arm Assembly See Figure 7-32. Insert the assembly into the transmis- sion case. Verify that screw sits inside shifter shaft lever See Figure 7-32. Install a new seal. Install washer (1) See Figure 7-35. Install shifter lever (9) on the shifter shaft end using screw (8). Tighten to 18-22 ft-lbs (24.4- 2006 Softail: Transmission

4

3 Shifter shaft lever Shifter shaft lever spring Spring spring. See Figure 7-33. and a new retaining ring (2). 29.8 Nm).

8253 7417 1. 2. 3. 4.
4. 5. 6.

Figure 7-37. Pressing in Seal NOTE If the main drive gear needle bearings and/or seal need to be replaced, continue as follows. Otherwise, proceed to Remove seal and old needle bearings. NOTE To install the inner main drive gear needle bearings and seal, use MAIN DRIVE GEAR BEARING and SEAL INSTALLA- TION TOOL (Part No. HD-37842-A). See Figure 7-36. Install clutch side needle bearing using an arbor press and the 0.315 in. step end of tool as shown. Press until tool is flush. See Figure 7-37. Turn over tool and press in seal using See Figure 7-38. Turn over the main drive gear in the arbor press.

HOME 8254 ASSEMBLY. 8. 9. 10. the 0.090 in. step. 11. inner bearing. ASSEMBLY 1. sion case. 2. lever. assembly. 3.