Page 134 - 2006 HARLEY FLSTCI SERVICE MANUAL

3-59

NO With ignition OFF, check continuity between siren connector [142B] Terminal 3 and Breakout Box cavity 12. Then measure continuity between siren connector [142B] Terminal 1 and Breakout Box cavity 1. Is continuity present? NO Repair open wire. NO Replace siren. NO Replace siren. 2006 Softail: TSM & TSSM

1
YES Locate and repair short between BN/GY and BK wires.

Check for battery voltage at siren sensor connector [142B]. With ignition ON, measure voltage between terminal 3 (BK) and terminal 1 (BN/GY). Is battery voltage present? NO Disconnect siren from Breakout Box. Measure resistance between siren connector [142A] Terminal 2 and 3. is resistance between 120,000-200,000 ohms with siren disconnected? YES Connect siren to a known good motorcycle. Arm and activate siren to verify operation. Disarm siren. Did siren operate correctly? YES Replace TSSM. Learn password and perform setup. Clear DTCs using speedometer self diagnostics. See 3.10 S

NO Locate and repair open on Lt GN/BN wire.

2 3 lamp.
ALARM OUTPUT: DTC B1131, B132 YES With ignition OFF, measure resistance between siren connector [142B] Terminal 2 and Breakout Box cavity 11 (gray). Is resistance less than 1 ohm? YES Measure resistance between Breakout Box cavity 11 and chassis ground. Is resistance less than 1 ohm? YES Locate and repair grounded Lt GN/BN wire.

HOME Test 3.17 1