Page 297 - 2006 HARLEY FLSTCI SERVICE MANUAL

At some point in the flow chart you may be instructed to jump directly to a the box with the bold asterisk. Disregard the asterisk (but not the instruction box) if your normal pro- gression through the chart brings 5.6 SPEEDOMETER SELF DIAGNOSTICS.

NO Repair connector. you to this location. Clear codes using speedometer self diagnostics. See Confirm proper operation with no check engine lamp.

Continued from Test 5.21 (Part 1 of 2). Disconnect ET sensor connector [90B] and examine for damage. Connector OK? NO Examine PK/Y wire in harness for open circuit and repair. NO Examine BK/W wire in harness for open circuit and repair. NO Examine PK/Y and BK/W wires in harness for short between these two circuits and repair. NO Examine harness for short to ground and repair. NO Replace 4 ET sensor.

2006 Softail: Engine Management (EFI)

Test 5.21 (Part 2 of 2) ET SENSOR: DTC P0117, P0118 YES Using a DVOM, measure the resistance between ET sensor connector [90B] Terminal A and ECM cavity 6 on Breakout Box. Resistance less than 1.0 ohm? YES Using a DVOM, measure the resistance between ET sensor connector [90B] Terminal B and ECM cavity 26 on Breakout Box. Resistance less than 1.0 ohm? YES Using a DVOM, measure the resistance between ECM cavity 6 and cavity 26 on Breakout Box. Resistance greater than 1.0 megohm? YES Using a DVOM, measure the resistance between ECM cavity 6 on Breakout Box and ground. Resistance greater than 1

HOME 2 2 3 5-78