Page 344 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 344

6-11







                    Lock tab    Lock bar                                                                  See Figure 6-11. Fit the attachment clip to the pin hous- ing, if removed. Place large end of slot on attachment T-stud on frame. Push assembly forward to  2006 Softail: Wiring



                                                 Pin housing       Attachment clip            Attachment clip installed  Figure 6-11. Attachment Clip Installation






                    5893                      5892                        5891                                clip over  engage small end of slot.




                                                                                                          2.














            NOTE An ELECTRICAL  TERMINAL CRIMP  TOOL (Part No. HD- 39965) is used to install Deutsch pin and socket terminals on new terminals must be installed, see Crimping Fit wire seal into back of pin housing. Grasp crimped pin approximately 1.0 in. (25.4 mm) behind the contact bar- rel. Gently push pins through holes in wire seal into their respective numbered locations. Feed pin into chamber until it “clicks” in place. Verify that pin will not back out of chamber; a slight tug on the wire will confirm that it is Insert tapered end of secondary locking wedge into pin housing and press down until it snaps in place.  The


                     Instructions in this section.  properly locked in place.  installed position.  on the pin side.  engage the other latch.







          HOME     wires. If   3.       4.          ●        ●                  1.                                        ries, are black.        same.
   339   340   341   342   343   344   345   346   347   348   349