Page 347 - 2006 HARLEY FLSTCI SERVICE MANUAL

HEMET, CA. 92343-0161 (714) 929-120
6.4 HEMET RYAN AIRPORT, P .O. BOX 878 JDG360-1
INDUSTRIAL PRODUCTS DIV
HDT - 48 - 00

Figure 6-15. Selector Knob 2 Figure 6-16. Indentor Points

This HAND tool must not be used in any powered "PRESS'' as defined by OSHA CFR 1910.211 (46) Indentor cover Contact Indentor points 1

d0253x8x 1. 2. 3. 3 d0254x8x

MINI-DEUTSCH CONNECTORS

For Size 20, 16 and 12 Contacts Mini-Deutsch connectors make use of a solid barrel contact without crimp tails. As a result, a special TERMINAL CRIMP TOOL (Part No. HD-42879) is needed to install pin and 3 This HAND tool must not be used in any powered "PRESS'' as defined by OSHA CFR 1910.211 (46) 4 Figure 6-14. Deutsch Solid Barrel Contact Crimp Tool (Part No. HD-42879) CRIMPING INSTRUCTIONS Squeeze the handles to cycle the crimp tool to the fully See Figure 6-14. Remove locking pin (3) from selector See Figure 6-15. Raise selector knob and rotate until selected wire size stamped on whe

Wire Range 26-12 AWG socket terminals on wires. Adjusting screw Selector knob “SEL. NO.” arrow. wise (in) until it stops. with the wire end out. Tighten knurled locknut. 2006 Softail: Wiring
GENERAL 1 Locknut Locking pin open position. knob (4).

HOME d0252x8x 2 1. 2. 3. 4. 1. 2. 3. 4. 5. 6. 7. 6-14