Page 350 - 2006 HARLEY FLSTCI SERVICE MANUAL

6-17

PART NO. 70585-93 70586-93 70587-93 2006 Softail: Wiring

Crimp wire ends Melted sealant after heating/cooling Figure 6-19. Installing Sealed Butt Splice Connectors Table 6-2. Common Sealed Splices CONNECTOR COLOR Red Blue Yellow

Metal insert

d0257x8x GAUGE WIRE 18-20 14-16 10-12

The tool automatically opens when the crimping
Repeat steps 5, 6, and 7 on the other side of the butt
Squeeze the handles of the crimp tool until tightly closed.
See Figure 6-19. Feed the wire into the butt splice con-
nector until the stripped end contacts the wire stop inside

NOTE If adjacent wires are being spliced, stagger the splices so that the butt splice connectors are spaced at different positions 1WARNING 1WARNING Use caution when operating the UltraTorch UT-100 or any other radiant heating device. Read the manufacturers instructions carefully before use. Always keep hands away from tool tip area and heat shrink attachment. Avoid directing the heat toward any fuel system compo- nent. Extreme heat can cause fuel ignition or explosion. Avoid directing heat toward any electrical system com- ponent other than the connectors on which heat shrink work is bein

could result in death or serious injury. exudes out both ends of the connector.

the metal insert. sequence is complete. splice connector. along the length of the wires. appearance.

HOME 6. 7. 8. 9. tool attachment. 10.