Page 962 - 2006 HARLEY FLSTCI SERVICE MANUAL

s0187x4x 4-37

1 3

Breather hose connection Mount (on back side) Purge hose to canister (carbureted models)
3 Figure 4-30. EVAP Canister Mount (Rear Wheel Removed For Clarity) 1 2 Vent hose from fuel tank and vapor valve) Clean air hose from air cleaner backplate Figure 4-31. Charcoal Canister Connections 2006 Softail: Fuel System

2

4 Canister Vapor valve

1. 2. 3. 4. d0112x4x 1. 2. 3.

canister bracket. Slide the canister to the left until it drops
To ensure correct assembly, See Figure 4-31. Note the two hose connections on the mark the hose to match the stamps on the canister. After See Figure 4-30. Slide canister into mounting bracket See Figure 4-31. Attach hoses to left side canister nip- See Figure 4-30. On carbureted models, attach breather hose connection (1) from air cleaner backplate to nipple Move rear wheel forward and place belt on sprocket. Then move wheel back and make sure brake disc is cen- Tighten axle nut and adjust belt tension. See 1.14 REAR
Remove two bolts on rear splash guard. Lift splash guard
from air cleaner backplate off nipple on right side of char-
On carbureted models, pull breather hose connection (1)
With a screwdriver, lift up the tang on the left side of the
Remove the cotter pin from the rear wheel axle, loosen
Support motorcycle so rear wheel is off the floor.
Figure 4-30. The EVAP charcoal canister is mounted
Then move the wheel as far as it will go
Move the wheel forward and slip the drive belt off the
the axle nut and turn the axle adjusting bolts all the way
CHARCOAL CANISTER 1WARNING 1WARNING prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) below the rear fork pivot. towards the rear of the motorcycle. up and over rear tire. free from the bracket. left side of the canister. hoses are marked, gently pull hoses off the canister. Remove canister. until canister clicks in place. ples as marked. on right side of charcoal canister. tered between brake pads. BELT DEFLECTION. Install the splash guard using two bolts.

HOME Removal To See 1. forward. 2. sprocket. 3. 4. coal canister. 5. 6. 7. Installation 1. 2. 3. 4. 5. 6.