Page 97 - Roberston & Sinclair Catalogue

Shank Type Tools
Carbide Tipped Router Bits
SOLID SURFACE ROUTER BITS
ACTUAL SIZE REFERENCE
ACTUAL SIZE REFERENCE
ROMAN OGEE
Produces shallow Roman Ogee bench top edge to retain water on the top, usually used in conjunction with LINSSM24. Rounding over bit to complete the form.
ROUNDING OVER BOWL BIT
Rounding over and bevel form for undermounting of bowls fitted with Nomark Bearing guide.
OD L2 Od
22 10 12.7
COUNTER TOP PROFILE ROMAN OGEE
PART NO.
LINSSM23
OD L2 Od
56 30 12.7
PART NO.
LINSSM2
ACTUAL SIZE REFERENCE
An all one piece lip forming bit with Nomark bearing guide.
OD L2 Od
25 24 12.7
FACE INLAY BITS
PART NO.
LINSSM6
SOLID SURFACE REPAIR KIT
ACTUAL SIZE REFERENCE
Where inlays are required these bits produce a choice of grooves to take veneer, brass, plastic or other strip material.
This repair kit is very similar to the Solid Surface Inlay and Seam Kit. The big difference is that the router bit has a 5° taper to it so that the repair doesn’t fall through the counter top.
A template is needed just as in the inlay kit, the procedure for routing is a little different though. This template is first attached to the counter top needing the repair. Then, with a special collar installed on the template guide provided, route around the inside of your pattern throwing the inside away.
Next move the template to the material you will make the repair from, except this time you will flip the template upside down before routing. This needs to be done since the inlay will need to be flipped over to fit into the repair.
The repair kit comes with complete instructions.
Test this repair kit on scrap material before starting the job.
PART NO.
LINRKDMP10
CED inlay SHK
29 3.0 12.7 29 12.0 12.7
PART NO.
LINSSM14 LINSSM16
KEY OD = Cutting Edge Diameter L2 = Cutting Edge Length (mm) Od = Shank Diameter (mm) L1 = Overall Length (mm)
All care has been taken to ensure information in this catalogue is accurate. However we reserve the right to make corrections without notification.
2-69