Page 157 - B6118-AEW-XX-XX-PP-A-0001_(P16)_Contractors Manual
P. 157
DESIGN
D5.2 Managers office
All McOpCo managers’ offices have been Floor
moved in the drive thru buildings in preparation Polysafe corona otter 5530 (grey) or ceramic
for the EotF programme. The typical solution tiled floor as kitchen specification.
has been to fit out the old booth one corridor
as a new office. Few franchisee restaurants 150mm skirting tile for all walls prior to wall
have benefited from this enabling work and so finishes beginning. Ceramic tile for tiled floors,
many managers offices will have to be moved continuous integral cove for vinyl.
in drive thru EotF projects. Below are the typical
requirements from a standard (booth 1) move. Walls
3mm hygienic cladding (white) with all
The standard (booth 1) office move is physically proprietary fixing strips, covers and coves.
impossible for a number of drive thru types
and so bespoke solutions must be sought on a Ceiling
restaurant by restaurant basis. 600x600mm gyprex satin spar tile with white
face, square edge fitted in a 15mm grid.
It is unlikely that managers offices will be
affected at instore restaurants however, as Doors
above, bespoke solutions must be found where Solid core with hardwood lippings. Balanced
such issues present themselves. laminate, polyrey cream to both sides. Vision
panel required.
When fitting out a new managers office, the
following specification should be used: Ironmongery
All ironmongery to SAA or stainless steel including;
300mm kick plates, D type pull handle, push
plate, door closer, door stop, 3 sets of hinges,
barrel lock (key to outside and thumb turn inside)
with escutcheons.
D5.2 Managers Office 2.0 09 February 2017
