Page 3 - B8773-AEW-XX-XX-PP-A-0001_[P4]_Contractors Manual
P. 3
Introduction
design brief to the shop fitting contractor who A F T
The purpose of this document is to provide The contractor’s fabrication and installation
both the Franchisee and the Shopfitting drawings must not deviate from the
contractor with a clearly defined statement requirements defined on the Clients
of requirements for a model typical store. approved plans without prior approval.
This also enables an accurate cost to be
established and a consistent corporate Where for any reason the shopfitting contractor
image to be achieved and maintained. identifies a need to vary the provision, this
must only be done with the express written
The use of descriptive text, schedules of permission of Domino’s Pizza UK & Ireland Ltd.
information, detail drawings and generic
standard details is intended to fully illustrate Any reference to Building Control, Building
D R
the corporate imaging and quality Regulations, Planning Permissions, British
requirements required by Domino’s Pizza UK Standards, and similar Statutory Bodies, should
& Ireland Ltd on behalf of the franchisee. be taken to refer equally to the equivalent
Scottish and Irish national institutions, and
This document is intended to form a detailed compliance is mandatory in the same way.
will prepare his own fabrication and installation
drawings, where required, and to provide a
fixed cost for the fit-out of a Domino’s Pizza store.