Page 13 - Preview

7. SELECTION OF OPERATION MODE
After INITIAL SET UP was completed and the BEFORE GENEO X TREATMENT steps described above were taken, select the desirable operation mode.
Treatment may commence by using either one of the three available operation modes: ‘TREATMENTS’, ‘MY TREATMENTS’ and ‘MANUAL’ as explained in Table 2 below.
Upon turning on the system, it will automatically run in ‘TREATMENTS’ mode and display the treatments menu shown in Fig. 14. Above. To switch to a different operation mode press the “menu” icon as shown in Fig. 24 below.
Note, that a treatment will not run if the treatment applicator is not properly connected to the main unit.
Table 2: GENEO X modes of operation
NOTE: make sure you connect the applicator(s) before turning the system ON. Once an applicator is not connected properly or missing, its key will appear dim on the screen. If applicators are disconnected, the system will indicate with one of the following messages:
“Please make sure applicator is connected” or “Applicators not connected. Please connect to continue (Fig. 16 above). Connect the applicators and press on the “V” button.
TREATMENTS
Variety of treatment protocols for your choice is displayed. The session will progress according to treatment type (Oxygeneo, massage) and parameters (treatment duration, intensity). The flow can be customized by the operator through manual adjustment of variables above and saved to the system.
MY TREATMENTS
Enables to run saved customized treatment protocols from the saved protocols list.
MANUAL
Switching from Oxygeneo to Massager is manual. No automatic flow.
Choose treatment type, and treatment parameters. Treatment parameters are set to default and may be adjusted by the operator.
14