Page 21 - Preview

13. OXYGENEO TREATMENT PROCEDURE
1. Make sure the skin in the treated area is cleared of any makeup, cream,
or serum. Clean and thoroughly dry the skin before treatment.
2. Attach the OxyPod to the applicator before commencing session (Fig
35-37).
3. Apply generous amount of the Primer Gel to the treated area (Fig.38).
4. Select the OxyGeneo option in the ‘Manual’ mode or choose one of the treatments from the ‘Treatment’ mode (according to chapters 9 or 10 above respectively). Make sure that the applicator's GREEN LED is ON.
5. Optionally adjust the default intensity and duration parameters. The applicator's GREEN LED is blinking to indicate parameters may be adjusted. The default values as well as the minimum and maximum allowable values are shown in table 3 below.
OXYGENEO PRE-SET TREATMENT PARAMETERS
Table 3: OxyGeneo Pre-Set Treatments Parameters
6. Remove applicator from cradle and follow by pressing the ‘start’ button on the applicator. The applicator will start to transmit energy and the GREEN LED will turn BLUE (Fig. 39).
7. Move the applicator using circular or linear movements while applying mild pressure over the entire treatment area. Avoid contact with eyes and mouth.
8. You may also utilize a stamping method (hold in place 2-3 seconds) at the end of the treatment.
9. Monitor sensation verbally and regularly throughout the treatment.
10. Adjustintensity(increaseordecrease)accordingtotreatedarea,patient tolerance and comfort, by using the (+) & (-) on the applicator.
Fig. 35-37
Fig. 38
|
||
Default
Min
Max
Default
Min
Max
Intensity
4
1
10
5
1
10
Duration
5
2
20
8
2
20
Fig. 39
22