Page 220 - Gas Detection Systems Training Manual
P. 220
7.1 Mapping and Assigning Relay Coils
To configure or manually control the Relay Module coils, you must launch the Relay Module Assignment Screen from the Relay Module Device Summary screen shown below (only when logged on as Supervisor):
By selecting a coil that you wish to assign or modify, the Relay Module Assignment Screen appears as shown below (in the following example, coil #5 is pressed):
By pressing the “Modify Assignment” button, the Coil Assignment Screen will be shown, allowing configuration and mapping of the coil as shown on the following page:
Sensor Electronics Corporation 5500 Lincoln Drive Minneapolis, Minnesota 55436 September 29th, 2006
Page 36 of 66
952-938-9486
SEC 3500 OI Supervisor Operator’s Manual Version 2.1.0095
