Page 95 - CRESTRON HOME OS-3
P. 95
Configure Source Routes
NOTES: Observe the following points when configuring source routes:
l If two media sources are routed to a DM NVX® device (via the Input 1 and Input 2 ports),
they may not be used at the same time. For example, if switching from Input 1 to Input 2
in a media zone, all media zones where Input 1 is selected switch to Input 2.
l Route CEC devices to the HDMI® input that matches the Control Port that was assigned
to the device.
l If the audio signal for a video source is routed to a SWAMP audio expander endpoint, the
video will display but no audio will be heard. This behavior occurs because the SWAMP
device is warming up and is corrected within a few seconds.
To configure source routing behavior for a media device:
1. Select a room from the left screen menu and then select a media device from the provided
options.
2. Assign an input source:
a. Tap an input channel from the Inputs list. The available sources are displayed.
b. Select the source connected to the input.
Product Manual — Doc. 8525Z Crestron Home™ OS • 95
