Page 166 - ICC IEBC 2018
P. 166

APPENDIX C



               Configurations A and B as defined in Table C104.2, and    One fastener shall  be  installed that connects each
               shall comply with the following conditions.               strap to the side of the associated retrofit stud.
                  1. Straps of sufficient length to meet the requirements   2. The horizontal  brace shall butt snugly against  the
                                                                                                         1
                    for the number of fasteners in accordance with Table  retrofit stud with  a maximum  gap of  /  inch  (6.4
                                                                                                          4
                    C104.4.2 and meet the end distance requirements of   mm).
                    Section C103.5.3 shall  be shaped around retrofit   3. Straps shall be permitted to be twisted to accommo-
                    studs and fastened to the edges of horizontal braces.    date the transition between the tops of retrofit studs
                    Straps shall wrap the back edge of the retrofit stud   and horizontal braces that follow the roof pitch.
                                                   1
                    snugly with  a maximum gap  of  /  inch  (6.4
                                                    4
                    mm). Rounded bends of straps shall be permitted.   [BS] C104.5 Connection of gable end wall to wall below.
                                                                  The  bottom chords or  bottom members  of wood-framed
                                                                  gable end walls shall be attached to the wall below using
                                       ELEVATION VIEW                         SECTION VIEW
                                                             REQUIRED
                                                            CONNECTION TO
                                                          HORIZONTAL BRACE



                                                        EXISTING GABLE END STUD





                                                         REQUIRED 2x RETROFIT
                                                           STUD W/ 3″ LONG
                                                          FASTENERS @ 6″ O.C.




                                     HEIGHT OF GABLE EN STUD > 8′-0″  (MATCH SIZE OF RETROFIT STUD)  2½″ O.C.
                                                                          ¾″ MIN.







                                                        50″ LONG SPLICE MEMBER
                                                       - CENTER ON SPLICE LOCATION




                                                       INSTALL MINIMUM (27) 3″ LONG
                                                                                          SPLICE RETROFIT STUD 36″ TO 48″ FROM BOTTOM
                                                     FASTENERS FROM SPLICE MEMBER
                                                      TO RETROFIT STUD (EACH SIDE OF
                                                           SPLICE LOCATION)





                                                             REQUIRED
                                                           CONNECTION TO
                                                          HORIZONTAL BRACE

                                                              NOTE:
                                  SPLICE LOCATION MAY BE REQUIRED AT TOP OF GABLE END STUD IF HEIGHT > 11′-0″ TO 12′-0″
             For SI: 1 inch = 25.4 mm, 1 foot = 304.8 mm.
                                                        [BS] FIGURE C104.3.8
                                                       RETROFIT STUD SPLICES

             2018 INTERNATIONAL EXISTING BUILDING CODE ®                                                         147
  Copyrighted © 2017 by, or licensed to, ICC (ALL RIGHTS RESERVED); licensed to UL, LLC pursuant to License Agreement with ICC. No further reproductions authorized or distribution authorized.
  ANY UNAUTHROIZED REPRODUCTION OR DISTRIBUTION IS A VIOLATION OF THE FEDERAL COPYRIGHT ACT AND THE LICENSE AGREEMENT; AND SUBJECT TO CIVIL AND CRIMINAL PENALTIES THEREUNDER.
   161   162   163   164   165   166   167   168   169   170   171