Page 18 - Router Boss Manual

Prepare to Cut
Remove the pattern board from the Router Boss and
clamp it together with the other end piece. Position the
two side pieces and clamp them in the Router Boss.

With the bit “zeroed” against the end of the wood,
position one of the side pieces, plus a business card,
beneath the plunge stop and lock the plunge stop at
this depth.

Turn the crank handle so the cursor reads at the first
setting — 0” in our case (or “zero” on the digital
readout). Slide the router out so the bit is in front of
and clear of the workpiece. Plunge and lock the router
depth, make sure the bit is clear of the workpiece, then
start the router and push the bit through the workpiece
to make the first cut.

18