Page 27 - Catalog For Chemical_NEW!! - FOR E-Book_Neat

PRODUCT INFORMATION

WELL-DS1010

INTRODUCTION other foam control agents. When used as a direct
food additive, sterile water must be used for dilution .
Foaming in aqueous solution or water is caused by Pre-dilute solution should be kept under agitation or
high concentrations of dissolved or suspended
solids, excessive alkalinity, and by saponifiable oils mildly agitated before use. Such dilution or
dispersion may provide greater ease of handling and
that form soaps. Foaming can be controlled to some
extent by adding special inhibitors that are move effective use of silicone. WELL-DS1010 can be
premixed in the batch during the initial product
unsaponifiable and stable toward hydrolysis. Foam is
composed of bubbles of steam separated form each formulation, or it can be metered into continuous
process systems by the use of metering pumps.
other by thin films of liquid system. There are
stabilized by repelling forces, principally electrical
charges, that arise at the steam-liquid interface. DOSAGE
Thinning of the liquid film is opposed by electrical The optimum concentration of WELL-DS1010 is
repulsion of similar charge on both surfaces, which dependent upon temperature, composition, viscosity
prevents rupturing and coalescence. Hydrophilic agitation, and other processing conditions.
colloids can induce foaming upon being adsorbed at Depending on the defoaming effectiveness required,
these interface. When stable bubbles pile upon the the quantity of WELL-DS1010 can be decrease or
surface of solution, solid dissolved or adsorbed in increase to establish the most economical
solution film pass into system and foam scale in heat concentration to apply.
exchanger surface and fouling in tube. When evaluating WELL-DS1010 it is suggested that
the evaluation be started at about 10 ppm silicone.
DESCRIPTION This starting point represents an average level of
silicone found to be effective in many application.
WELL-DS1010 is a 10 percent by weight active Except in food processing, these levels can then be
silicone antifoam emulsion specifically designed for
the prevention and suppression of foam in aqueous adjusted in either direction to determine the minimum
effective concentration for the specific system
systems. The product is stable over a wide pH range
and is recommended for use in all aspects of requiring foam control.
industrial fermentation, including food and drug
processing. FDA STATUS

WELL-DS1010 is prior sanctioned for use in food
PHYSICAL PROPERTIES processing in concentrations up to 100 ppm where
food standards permit. WELL-DS1010 may, also be
Appearance . . . . . . . . . . . . . . . . White, opaque liquid
Silicone Solids . . . . . . . . . . . . . . . . . . . . . .10% by wt. used as a component of adhesives used in articles
Viscosity at 25°C . . . . . . . . . . . . . . . . . . . . . 2,000 cs. intended for packaging, transporting and holding
Apparent Specific Gravity (at 25/25°C) . . . . . . . .1.00 food as a component of paper or paperboard in
Suitable Diluent . . . . . . . . . . . . . . . . . . . . . . . . .Water contact with aqueous, fatty and dry foods.

ADVANTAGES HANDLING AND STORAGE
WELL-DS1010 exhibits excellent storage stability
1. Easily added to aqueous foaming system.
2. Water dilutable stable emulsion, easy to use and when proper handling procedures are followed. As
handle. with, most emulsion, storage in a cool place (16-
3. Effective over a wide range of pH. 25°C) in tightly close containers will provide
4. Low viscosity emulsion assuring ease of handling maximum shelf life. Under these conditions. WELL-
and diluting. DS1010 has a shelf life of six months.
5. Prevent foam formation therefore improve product
yield. Meet FDA requirements. PACKAGING
WELL-DS1010 is available in steel drum of 200 Kgs.
APPLICATION net.

WELL-DS1010 may be used at full strength as
supplied, in a solvent dispersion, or in a blend with
TECHNICAL SERVICE
WELLMAN CO.,LTD HAS A STAFF OF TECHNICAL SERVICE
ENGINEERS WHO WILL ASSIST AND TRAIN YOUR MEN ON THE PROPER
EVALUATION AND APPLICATION OF OUR CHEMICALS AND GIVE
RECOMMENDATION TO ENSURE SMOOTH OPERATION
THIS SERVICE IS GIVE FREE OF CHARGE