Page 24 - IMER_2021-07_MPT_cat_en_Neat

Sph
Tph
KOINE 3

Continuous cycle spraying and mixing pump
50 Hz 60 Hz
Koine 3 230V/50Hz Sph - 3.4 kW Koine 3 230V/60Hz Sph - 3.4 kW
1106007 1106009

Sph
Sph

Tph
Sph Tph
Sph
Easy Start Up
Starting a plastering machine is always
Bifunctional grate safety sensor with a delicate phase, but not for Koine 3.
light signaling when the hopper grate is Easy start system:
removed and when the mixing chamber 1) Remove the cap and bring the water
motor is opened. It simplifies cleaning
Tph to the level
operations ensuring maximum safety.
Tph 2) Put the premixed in the hopper
3) Start the mixing motor

Description Operation
Continuous cycle mixing pump, suitable for pumping or spraying all dry Bagged material is poured into the hopper, where an agitator shaft
premixed materials: accompanies the material towards the mixing chamber.
• Cement / lime / gypsum plaster based
• Structural reinforcement mortars The water necessary to obtain the mixture is injected into the mixing
• Structural plasters chamber by a stainless steel pump. The water flow is kept constant
• Restorative plasters through a particular stabilization system and controlled by a valve that
• Stucco starts or stops the flow if necessary.
• Binders / mortars for injections
• Grout / Core-Fill Grout The amount of water in the mixture can be viewed in the flow meter and
Sph
• Glues for thermal insulation coatings can be adjusted according to the needs through a micrometric valve. The
• Thermal insulating screeds based on cork or polystyrene material is mixed with water and immediately sucked by the eccentric
• Insulating plasters based on polystyrene or cork screw pump and pushed into the pipe until it reaches the end of the spray
• Fireproofing mortar gun. With the help of the air supplied by the standard built-in compressor,
• Self-levelling cement-based screeds the gun allows spraying the material on the application area from a
• Self-levelling anhydride-based screeds distance of about 20 cm.
Tph
The product used can be poured into the machine hopper directly from The material flow can be started or stopped directly from the spray gun
the bags. by opening or closing the air valve.
Koine 3 is a small size plastering machine that can be easily dismantled, ideal Washing is simple, very fast and without water and material spilling in the
for all renovation works, where accessible spaces are limited and portability work area.
is of fundamental importance.
Before washing, the material in the hopper must be pumped until the
The high efficiency of the electrical components, including the exclusive hopper is completely empty. Then the mixing chamber can be cleaned
IMER R2 inverter, allows Koine 3 to work even with the minimum electrical by inserting the special scraper supplied with the machine in place of the
power available in most homes (3 kW). Select the most suitable among the mixing shaft.
four pumping speeds available, which can be shown on the display.
Koine 3 is equipped with safety protections that immediately stop the
electric motors if the hopper grate is removed or the mixing chamber
is opened, signaling the event with an indicator light and indication on
the display. The machine is also equipped with status diagnostics, which
ensures electrical protection in any case of system overload or use anomaly.
22

Sph

Tph