Page 591 - Chief Architect Reference Manual

Window Specification Dialog

• An additional Right Inside Corner can be
specified in a similar manner. Note: The Left and Right settings on this
panel refer to the window’s exterior.
4 The Bottom Corners settings allow
you to raise the heights of the bottom The following diagram represents added
corners, as measured from the bottom of the Inner corners using open circles and the left
window specified on the General Panel. and right corners using solid black circles:
• Check Left to raise the height of the bot-
tom left corner.
• Specify the Height of the bottom left cor-
ner. This value cannot exceed the Height
of the Left Side.

• A has different left and right Side Heights
with no Top Inside Corner added.
• The height of the Bottom Right corner • B has matching left and right heights with
can be raised in a similar manner. an added Top Inside Corner.

5 A preview of the selected window • C is the same as B, except that the left
displays here. You may want to rotate and right Side Heights have been short-
the view so the window’s exterior can be ened to 1/4”.
seen. See “Dialog Preview Panes” on page • D is the same as B except it has two
42.
added Top Inside Corners.
• E is the same as A except that the Bottom
Right Corner has been raised.

Arch Panel
The settings on ARCH panel of the Mulled constructed with horizontal, straight tops all
Unit Specification dialog define the overall at the same height.
shape of the blocked unit’s top. If the mulled The ARCH panel is not available for window
unit already includes a component window symbols, and its settings are not available if
with an arch, these settings cannot be the selected window has been modified using
modified. If you intend to arch the top of a the Shape Panel.
mulled unit, the top components should be

591