Page 590 - Chief Architect Reference Manual

Chief Architect X10 Reference Manual

has an arch specified on the ARCH panel, it
will be removed. Note: The Left and Right settings on this
panel refer to the window’s exterior.
The SHAPE panel is not available for mulled
units or window symbols.

1 Window Width displays for reference. 2 Specify the height of the window’s Left
It can be changed on the General and Right Sides, as measured from the
Panel. bottom of the window. By default, these
• Click Match Roof to match the angle of settings match the window’s Height.
the top of the window to the pitch of the The Top Inside Corners settings allow
roof above by changing its Sides heights, 3 you to create a second set of top corners
below. If either Top Inside Corner box is with angled edges between them and the
checked, it will become unchecked. outside top corners.

• Check Left to add an additional corner
Match Roof does not work for curved along the top edge.
roofs, has no effect if the window is not
in a gable end wall, and is not available in • Specify the Height of the left inner cor-
the Window Defaults dialog. ner, as seen from the exterior, measured
from the bottom of the window.
• Click Revert All to restore the window to
its original shape, type and arch settings. • Specify the Offset of the left inner cor-
ner, as measured from the left side of the
window.

590