Page 786 - Chief Architect Reference Manual

Chief Architect X10 Reference Manual

this box to enable the two settings that
follow and define the ceiling finish as part
of the roof planes instead. When this is
unchecked, you can specify the Ceiling
Surface material on the Materials Panel.
• Check Has Ceiling to enable the Ceiling
Thickness option. When this box is
unchecked, the selected roof plane will
have no ceiling surface at all and the
With Higher Eaves Boxed checked “Ceiling Surface” component will not be
available on the MATERIALS panel.
• By default, Boxed Eaves extend from the
inside edge of the roof fascia to the exte- • Specify the Ceiling Thickness, which is
rior Main Layer of the wall, enclosing the the thickness of the bottom surface of the
overhang area. If an exterior room with ceiling plane.
Use Soffit Surface for Ceiling checked is 3 Specify the material components to
located between the roof’s baseline and Supply for subsequently-built roof
an interior room, the Boxed Eave will planes. When checked, these items are
extend across that room, as well. You can calculated in the Materials List. See
instead uncheck Default to Overhang “Materials Lists” on page 1263. Only Gutter
and specify the Length of the boxed is available in the Roof Plane Specification
eaves. Not available if Flush Eave is dialog.
checked.
• Uncheck Gutter to not include gutters on
2 Specify where Ceiling Break Lines subsequently-built roof planes. This
display. See “Special Ceilings” on page option affects both the Materials List and
430. 3D views.
• Display At Finish Intersection positions • Check Edge Flashing to calculate edge
ceiling break lines where the ceiling fin- flashing in the Materials List when one or
ish surfaces intersect. more roof planes is against a wall.
• Select Display At Framing Intersection • Check Ridge Vent to calculate ridge vent-
to position ceiling break lines where the ing in the Materials List.
ceiling framing surfaces intersect. • Check Metal Drip Edge at Eave to cal-
In Chief Architect Interiors, specify how the culate metal drip edge along the eaves in
Ceiling surface on the underside of roof the Materials List.
planes is built. See “Vaulted and Cathedral • Check Metal Drip Edge at Gable to cal-
Ceilings” on page 431. culate metal drip edge along any gable
• When Use Room Ceiling Finish is eaves in the Materials List.
checked, the ceiling finish thickness and • Check Valley Flashing to calculate valley
material on the undersides of roof planes flashing in the Materials List when two or
are defined by the room below. Uncheck more roof planes form a valley.

786