Page 16 - Low Side Washer
P. 16

LOW SIDE WASHER


             Installation


             Tunnel Placement

                 When placing a piece of equipment, tunnel depth will vary from site to site. Be sure to allow an
                 adequate operating envelope
                 There are three traditional installation configurations for the Low Side Washer.
                    •   Standard, stand alone
                    •   Staggered with a set of Wave Wraps™
                    •   Staggered with a set of Gyro Wraps™
                 Shown in figures 1a, 1b and 1c are the floor dimensions for each configuration.
                    1)  Position the side wheel stand assemblies in the appropriate tunnel location (FIG 1a, FIG 1b or FIG
                       1c).
                    2)  Placing a level on the vertical post, place shims under the base plate as needed to make vertical
                       post plumb.
                    Note:  Shims not supplied by Belanger, Inc.
                    3)  Repeat leveling process on opposite side.
                    4)  Once stands are level, lag them to the floor using the supplied lag bolts.





















































              12            Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681         1MANUL858
   11   12   13   14   15   16   17   18   19   20   21