Page 30 - Low Side Washer

LOW SIDE WASHER

Installation

Waves and Fins Cleaning Material

Lower Side Wheels
The wash material fills for the lower side-wheels are the same as the Belanger, Inc. Low Side
Washer. This section will assist in the installation of the lower side-wheel wash material.

CAUTION

Certain machine configurations require the driver side wheel to use 22” Fins™. Otherwise, all Fins™ will
be 24”. If you have received 22” Fins™ with your order, load wash material accordingly.
Do not install any cleaning material until all equipment has been installed, turned on and checked for
hydraulic, pneumatic and water leaks.
1) Install bottom drive wave and seat counter-bore over the drive plate.

Counter-bore

2) Locate the 24” Fins™. Place 4 pieces over pins on bottom drive Wave™. One piece of wash
material should straddle the opening on each Wave™.

3) Install next Wave™ with slot opposite the opening on the previous one.
4) Repeat steps 2 and 3 until 9 waves have been stacked on top of the bottom Wave™ (total of 10
rows of wash material).
5) Press down on the top Wave™ stack to seat the wash material and verify the bottom Wave™ is
on the drive plate.

26 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL858