Page 41 - Full Side Washer Signature® Series
P. 41

FULL SIDE WASHER Signature ® Series


                       Maintenance


                       Trouble Shooting

                                         Problem                                    Solution

                           Wobbling Boom or Shaft                  •   Check for missing pieces or damaged cleaning
                                                                       material
                                                                   •   Check Bearings for wear
                                                                   •   Check for bent shaft
                                                                   •   Check shock for leaking oil, loose bolts or worn out
                                                                       rubber mount grommet

                           Boom not pivoting inward                •   Confirm output is set to “AUTO” position

                                                                   •   Verify air feeds are in proper location
                                                                   •   Confirm that air is working properly on both sides of
                                                                       air cylinder, rebuild or replace if necessary

                           Brush is turning too slow               •   Confirm flow control setting is all the way open

                                                                   •   Confirm hydraulic unit has 1000 – 1100 PSI
                                                                   •   Replace motor on hydraulic unit












































                       1MANUL856         Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681        37
   36   37   38   39   40   41   42   43   44   45   46