Page 30 - QuickFire® Wrap Around Mix & Match

QUICKFIRE® WRAP AROUND

Installation

Securing the Head Assembly to the Boom: Hydraulic

Locate the two side-wheel shafts.
1) Loosen both setscrews in each of the shaft bearings.
Close-up view of head assembly.

Bearing set screw
(typical)

4) Locate the accessory box and separate its contents.
5) Slide the shaft up through both bearings until the shaft of the hydraulic motor is inside of the side-
wheel shaft.
Note: Woodruff Key is to be inserted in the Hydraulic Motor Shaft.

6) Slide the supplied Woodruff Key into the slot at the top of the shaft.
7) Secure the supplied split-locking collar into position as shown below. This will hold the shaft in
place. Be sure that the Woodruff Key is positioned at 90° to the split in the collar as shown
in the image below.

Hydraulic Motor shaft
Split locking collar Woodruff key

Shaft bearing Split locking collar

Top View

8) Tighten all the setscrews on both bearings.

26 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL825