Page 32 - QuickFire® Wrap Around Mix & Match

QUICKFIRE® WRAP AROUND

Installation

Securing the Head Assembly to the Boom: Electric

Installing Electric Drive Shaft Components
The shaft is held in place using a steel key, two setscrews in each of the two bearings and a split-locking collar.
There is a groove in the shaft to accommodate the locking collar. The setscrews in the bearings are shown in a
close-up image at the bottom of this page. See the images below to understand how the complete assembly goes
together then follow the instructions on the next page.

Key
Key

Locking Collar

Locking Collar Bearing

2) Locate the Bearing Mount shown below and notice the slotted opening. That is to allow access to
the bearings setscrews and grease fitting. Be sure to align these components in a way that they
can be accessed.

Bearing Mount
Be sure to align bearings
setscrews and the grease fitting
in a way that they can be
accessed

3) Loosen both setscrews in each of the shaft bearings.

You may need to loosen these
four bolts in order to slide the
shaft up through the bearings.
If that is indeed necessary, be
sure to retighten them once
the shaft is in place

Lower bearing set Be sure to align bearings
screw (typical) setscrews and the grease fitting
in a way that they can be
accessed

4) Locate the two side-wheel shafts. Locate the accessory box and separate its contents.

28 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL825