Page 11 - AirBlade® Dryer Signature® Series

AIRBLADE® DRYER Signature ® Series

Introduction

When assembling the AirBlade® Dryer, pay close attention to the required operating envelope. That is the space
needed to operate properly shown in the drawings.

This manual will cover all procedures for all available systems.
It would be very beneficial to have a leveler of some sort on hand. In order to achieve
optimum performance, the Air Cannon™ nozzles for the 40HP, 60HP and the 100HP
systems should be mounted in specific positions. Levelers can be purchased at any good
hardware store (Home Depot).
This document is laid out in four sections.
Typical Leveler
• 2 Nozzle Floor Mount System
• 4 Nozzle Floor Mount System
• 6 Nozzle Floor Mount System
• 10 Nozzle Floor Mount System
Refer to the supplied drawings for positioning nozzles to the
proper angles. Nozzle location and positioning was determined
at the factory to fit a wide brand of vehicles. Your installation
preference may vary based on vehicle and building restraints.

Image above shows 6 Nozzle, 60hp system

1MANUL009 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681 7