Page 348 - Wurth Total Catalogue

POWERBOND

High-strength two-component epoxy
resin system for repairs to
motor-vehicle bodies.

• High-strength epoxy resin adhesive.
• The repair restores the original strength and
stiffness.
• Fewer spot welds.
• Meets the requirements of motor-vehicle
manufacturers.
• Glass-particle technology.
• Even if strong pressure is exerted,
Description Contents Art. No. Pack Qty. an adhesive thickness of 0.7 to 1.2mm
Powerbond Motor-Vehicle 225ml 0893 450 100 remains.
Body Adhesive 1/6 • Excellent stability.
Positive Mixer - 0891 450 101 15 • The adhesive will not run on vertical
Application Gun - 0891 450 100 1 surfaces (thixotropic).
• Excellent corrosion protection.
• The original rust resistance is
Replaceable parts
maintained.
• Corrosion is prevented at welds.
• Can be through-welded.
• Can be ground and painted over.
• Free of silicone and VOC.

Technical Data Applications:
Chemical basis Epoxy resin Structural adhesive for steel, aluminum and
Color black fiber-reinforced plastics (FRP, CFRP). For gluing
Density 1.1 g/cm³ motor-vehicle body parts such as side-walls, wheel
Application temperature +15°C to +25°C arches, roof and door plates.
Application time 60 min.*
Hardening time 4 hr.* Note:
Final strength after 72 hr.* Not suited for load-bearing vehicle body parts
Shore D hardness (DIN 53505) 80 (e.g. A-pillar, frame side bar). If body parts are
Tensile strength (ASTM D-638) 30 MPa* only partially replaced, do not glue on visible
Tensile shear strength (EN 1465) 1.7 MPa (after 4 hr.)* surfaces since shadow seams may appear.
13.3 MPa (after 8 hr.)* Observe the vehicle manufacturer’s repair
19.0 MPa (after 17 hr.)* instructions.
Resistant to Fuels (petrol, Diesel oil), motor and transmission oil, coolant.
Thermal stability –30°C to +120°C (for short peaks up to +190°C)
Durability 12 months

How the glass-particle technology works The glass particles prevent
the adhesive from being
completely squeezed out Partner Products:
Metal Adhesive by high fixation pressure.
(sheet-metal) with glass particles Acetone Cleaner
This ensures that the Belt and Sander
0.7-1.2 mm Pressed-on adhesive necessary minimum amount DBS 3600
with glass particles of adhesive remains between Flexi-Disc
AUS. pub. 01/11 © parts to be glued. Nylon Fleece Disk
as “distance keepers”
Powerlocs
This information is only a recommendation based on our experience. Preliminary testing required.
05 4221