Page 42 - Wurth Total Catalogue

CARBIDE BURRS WITH MX TOOTHING

Steel Stainless Steel Non-ferrous metals

Similar to 8032/8033 – Instructions:
cross toothing For the correct speed (n) and cutting speed (Vc)
for the material to be processed, please refer to
All-purpose MX toothing is suitable for the application table. Properties - Tool life: ●●●○
processing stainless steel, steel under
60 HRC, grey cast iron, weld seams, Applications:
tempered steels and hard plastics Deburring with robot technology, removal
of casting burrs on inner edges, fine surface
Good surface quality with a high processing, buffing and smoothing of weld seams
material removal rate in visible areas, shaping, chamfering, fitting work
Time-consuming reworking is reduced to a during installation and general deburring work.
minimum.

CARBIDE BURRS WITH ALUMINIUM TOOTHING

Aluminium Plastic Non-ferrous metals

Similar to 8032/8033. Applications:
Suitable for processing contours, deburring inner
For coarse machining with a high rate of material bores, milling out in preparation for application
removal, yet with very high surface quality. welding, milling work (deburring, weld seam Properties - Tool life: ●●●○
processing, contour processing etc.), even in small
Large chip volume with high machining and sensitive components in machine, mould and
performance. model construction.
Thanks to an application-optimized cutting
geometry. Instructions:
For the correct speed (n) and cutting speed (Vc)
Smooth running, even at high cutting for the material to be processed, please refer to
speeds. the application table.
The aluminium toothing functions best up to a
cutting speed (Vc) of 1,100 m/min, where it
exhibits smooth running behaviour.

AUS. pub. 04/17 ©

02 1501