Page 1049 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - FRONT DIFFERENTIAL ASSEMBLY 34-19

3 . Adjust the engagement mark of the driving and driven gears

Driven Gear Engagement Cause Adjustment Steps
Mark

1.Move driven gear away
Driving gear too far away from fromdriving gear
driven gear 2.Move driving gear closer
todriven gear

1.Move driven gear closer to
Driving gear too close to driven driving gear
gear 2.Move driving gear away
fromdriven gear

1.Move driven gear away
Driven gear too close to driving fromdriving gear
gear 2.Move driving gear away
fromdriven gear

1.Move driven gear closer to
Driven gear too far away from driving gear
driving gear 2.Move driving gear closer
todriven gear

NOTICE:
Adjust the driven gear. (Replace the spacer of the differential bearing. Refer to "Chapter 34
Axle & Transmission Shaft - Front Differential Assembly, Overhaul") Adjust the driving gear.
(Replace the spacer of the driving gear. Refer to "Chapter 34 Axle & Transmission Shaft
- Front Driving Gear, Overhaul") Check the engagement mark again and make proper
adjustment, until the right mark is achieved.

34
4. Check the engagement mark again and
make proper adjustment, until the right
mark is achieved
(a). Measure the gear side clearance between
the half axle gear and planetary gear with a
dial indicator.
Gear side clearance between half axle
gear and planetary gear : 0.05~0.1mm
Maximum : 0.2mm
If the clearance exceeds the limit, check
the end clearance of the half axle gear.
(Refer to "Chapter 34 Axle & Transmission
Shaft - Front Differential Assembly,
Checking & Adjustment")

Page 1049