Page 1068 - Foton Workshop Manual - Aumark (BJ1099)

34-38 AXLE AND PROPELLER SHAFT - DRIVING GEAR

(i). Install the pinion flange assembly.

fuwx34059

(j). Tighten the nut.
Torque:186~245N•m

fuwx34058

(k). Measure the driving gear startup tightening
torque with a Torque wrench.
Startup Torque : 0.49~0.69N•m
NOTICE:
Don't unscrew the nut to reduce the startup
Torque.
NOTICE
If the startup Torque exceeds the limit, replace the
driving gear bearing sleeve. (Refer to "Chapter 34
fuwx34054 Axle & Transmission Shaft - Front Driving Gear,
Overhaul") If the startup Torque is below the limit,
take the following actions.

(l). Further tighten the nut.
Torque (increase) : 5N·m
Torque (max.) : 245N·m

fuwx34056

Page 1068