Page 1069 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - DRIVING GEAR 34-39

(m). Measure the driving gear startup tightening
torque with a Torque wrench again.
Startup Torque : 0.49~0.69N•m
NOTICE:
If the startup Torque is still below the limit, repeat
Steps (m)-(n) until it reaches the required range. If
the nut Torque exceeds the maximum value while
the driving gear startup Torque is still below the
limit, replace a new driving gear bearing sleeve.
fuwx34054 (Refer to "Chapter 34 Axle & Transmission Shaft -
Driving Gear, Overhaul")

(n). Lock the nut.

fuwx34057

8. Check the engagement mark of the driving and driven gears (Refer to "Chapter 34
Axle & Transmission Shaft - Front Differential Assembly, Checking & Adjustment")
9. Install the front differential assembly (Refer to "Chapter 34 Axle & Transmission
Shaft - Front Reducer Assembly, Replacement")
10. Install the main reducer assembly (Refer to "Chapter 34 Axle & Transmission Shaft -
Front Main Reducer Assembly, Replacement")
11. Top up the main reducer gear oil (Refer to "Chapter 34 Axle & Transmission Shaft -
Main Reducer Gear Oil, Replacement") 34

Page 1069