Page 1566 - Foton Workshop Manual - Aumark (BJ1099)

51-26 WINDOWS AND REARVIEW MIRRORS - REAR WINDSCREEN

7. Install the rear windscreen assembly
(a). Apply black polyurethane glass sealant on
the specified area with sealant gun.
NOTICE:
Don't apply too much glass sealant. If apply the
sealant on the non-specified area by accident,
remove it with cloth before it's dried.

(b). Install the rear windscreen assembly.
• Mount the rear windscreen assembly
with sucker in place as illustrated.
• Check and confirm the contact surface of
the rear windscreen edge is flat.
• Align the mark on the rear windscreen
with the body.
(c). Install the rear windscreen assembly.
• Before installation, remove the adhesive
sheet on the rear windscreen interior trim
sealant.
• Mount the rear windscreen with sucker
as marked and gently press the edge.
• Gently press the front surface of the rear
windscreen to ensure close attachment.
• If necessary, adjust the level or position
of sealant application with scraper.
• Hold the rear windscreen with tape until
the applied sealant is dried.
NOTICE:
Remove the tape after at least 4 hours. Check and confirm the rear windscreen stop
block is installed in the body in place. Check the clearance between the body and the rear
windscreen.
8. Check for leakage and repair it if needed
(a). When the glass sealant is dried, apply
some water from the outside. Check and
ensure there is no leakage.
(b). If any leakage, apply glass sealant after it
is dried.
(c). Remove the tape.

Page 1566