Page 970 - Foton Workshop Manual - Aumark (BJ1099)

31-10 FRONT SUSPENSION - FRONT WHEEL ALIGNMENT

8. Check the front wheel hub
(a). Measure the distance D between the
central lines on two front treads of two front
wheels and the distance B between the
central lines on two rear treads of two front
wheels, so that the difference between A
and D equals to the front hub value.
Front wheel hub standard(A-B):
2.2±1mm(10'±5')

NOTICE:
After the adjustment of four wheel alignment parameters, check and adjust the maximum
turning angles of the wheels RH and LH.

9. Adjust the Maximum Turning Angles of the
Wheels RH and LH
(a). Adjust the left and right wheel turning
angles by changing the steering tie rod. If
the inner left turning angle is small,shorten
the left tie rod and extends the right tie rod
to the same extent, and vice versa.
(b). After the adjustment of steering angle for
the left and right wheels, adjust the front
wheels to straightly forward direction. If
the steering wheel fails to be the middle
vertical status, align and install the steering
wheel.

10. Check the Maximum Turning Angle of the
Front Wheel
NOTICE:
The turning angles of the wheels RH and LH
shall be the same. If it doesn't meet the standard,
readjust it.

Page 970