Page 2643 - Foton Workshop Manual - Sauvana
P. 2643

DIAGNOSIS-ENGINE CONTROL SYSTEM                             62-591
                 THE STARTER ROTATES BUT THE MOTORCAN’T START


                   Fault phenomenon                  Diagnosis logic                    Possible reasons

                                                                                   • Poor fuel qualityy
                                                                                   •  Leakage  in  the  gas  intake
                                                                                     system                         62
                                          • Spark plug                             • Low fuel pressure
                                          • Inlet system                           • Block in the air filter
                                          • Fuel temperature                       • Water temp sensor fault
                  The starter rotates but  • Coolant temperature sensor            • Air flow meter failure
                  the motorcan’t start    • Air flowmeter                           • Failure of idling control valve
                                          • Fuel injector                          • Injector does not work when
                                          • Ignition timing                          cold starts
                                          • The fuel quality                       • Leakage of the injector
                                                                                   • Ignition timing wrong
                                                                                   •  Too  low  of   t he  cylinder
                                                                                     compression pressure


                 Diagnosis Procedure
                 1.     Check the motor data


                 (a).   Ignition switch: LOCK。
                 (b).   Connect the diagnosis tool with the fault diagnosis connector (16pins) on the lower
                        left of the dashboard.
                 (c).   Ignition switch: Turn on the ignition switch, and start the diagnostic tool.
                 (d).   Read the motor data shown on the diagnostic tool.


                 Check whether the data flow is normalor not.
                 YES>To step 2。
                 No >Maintenance related faults.


                 2.     Check the secondary ignition system


                 (a).   Unplug the fuel injector fuse.
                 (b).   Remove the high voltage wire and the spark plug.
                 (c).   Connect the spark plug with the high voltage wire and connect the spark plug
                        negative to the cylinder block.
                 (d).   Start the motor to test the secondary ignition system.

                 Is the inspection result normal?

                 YES>To step 4。
                 No >To step 3。







                                                                                                     Page 2643
   2638   2639   2640   2641   2642   2643   2644   2645   2646   2647   2648